How To Solve The Dust Accumulation Of Flue Gas Heat Exchanger in Power Plant

Oct 30, 2025

Leave a message

After long-term use, a large amount of dust accumulates on the heat exchange surface of the flue gas heat exchanger in a power plant, causing blockage of the medium channel and reducing the heat transfer efficiency of the equipment. Therefore, understanding the cause of blockage of the flue gas heat exchanger is of great significance to solving the problem of dust accumulation and corrosion.

news-1037-542

 

Causes of dust accumulation in flue gas heat exchanger:

The flue gas heat exchanger in the power plant is responsible for improving fuel conditions, reducing incomplete combustion, lowering exhaust gas temperature and improving boiler efficiency. The reasons for the blockage of the flue gas heat exchanger in the power plant are related to the high ash content of the flue gas, the type of coal fuel and incomplete combustion.

The dry basis ash content in the coal is proportional to the dust content in the flue gas. When the dry basis ash content is <27%, the mass concentration of dust is maintained at 150mg/m3 or less; when the dry basis ash content is >32%, the mass concentration of dust is maintained at 250mg/m3 or more; when the dry basis ash content is >37%, the mass concentration of dust is maintained at 350mg/m3 or more. Flue gas with high dust content continues to enter the equipment for a long time, and the volatile phase condenses and agglomerates, and gathers on the heat exchange surface during the flow process to form an ash layer.

 

Solution to dust accumulation in flue gas heat exchanger of power plant:

1. Fuel selection. The more impurities the fuel contains, the more fine particles that are difficult to burn during the combustion process, which naturally form a large amount of ash accumulation in the furnace. Choosing higher quality coal fuel can reduce the frequency of ash accumulation.

2. Use a soot blower. A soot blower is a device used for cleaning. It uses steam, compressed air or pressurized water to remove ash and slag on the heating surface of the boiler. Regular soot blowing can improve the heat transfer effect, save 1-2% of fuel, and prevent a large amount of slag and ash accumulation, thereby improving the availability of the boiler.

 

In response to the dust accumulation problem during the operation of the flue gas heat exchanger in the power plant, Wintech designed a set of optimized heat exchanger structure, rationally selected the heat exchanger medium flow rate and combined with surface coating technology to prevent and control dust accumulation, wear and corrosion, and further optimize the efficiency of the flue gas heat exchanger.

Send Inquiry